| | 48330 ESC Speed Control
with Regenerative Braking |
| |
Specifications
|
 48330 ESC Speed Control 
|
| Voltage Input: | 14.5 to 58 VDC |
| Maximum Current: | 330 A |
Interface:
| Direct to receiver
with Futaba J connector |
| Weight: | 6.3 lbs |
Construction:
| Rugged aluminum
case, with interface board. |
| Width: | 5.71" |
| Length: | 7.48" |
| Height: | 2.05" case, 2.64" terminals |
|
Price: $430.00
In Stock
| |
| | This is the speed control you need to run your Etek
properly. This control is a modified version of the
standard Sevcon. It comes with the RCA Analog Interface.
Thanks to Richard Stuplich from www.killerbotics.com
for designing the Rx interface. |
| | RCA Analog Interface |
 | |
Use this board to interface between your
receiver and large speed controls.
|
|
The board closes a forward and reverse circuit
The board provides a 0-5K variable resistance
Ships with a Futaba J Cable installed
|
|
Price: $45.00
In Stock
|
| |
48330 Calibrator
Allows you to change Parameters
on 48330 ESC Speed Control |
 |
| | Programmable Parameters: |
Current Limit |
|
Regen Braking |
|
Acceleration Delay |
|
Deceleration Delay |
|
Maximum Speed |
|
Acceleration Curve Type | |
| Price: $225.00
In Stock
|
| |
 |
| | Go Back to Home Page Here |
| |
Go To Page Top |
| | Standard Bot Part Question ---------- Custom Bot Part Questions
|
